Tuesday, March 20, 2012

The mold has been split!

The Formula fiberglass mold was split into portions recently in order to make separate attachable fiberglass panels. HFM designers first sectioned off each portion to be cut, they then made the necessary cuts to section off the front and back sections of the mold. The designers then split the front portion of the mold into two. The three portions were then primed and ready for final refinements before a positive mold is made.


Caesar Viramontes (above) Sectioning off the mold for cutting 


Formula Designers making the first of two mold splits



 Each mold piece is primed and ready for detail corrections




Design students observing HFM's progress. You can too by visiting the design building at CSULB.

No comments:

Post a Comment